Audi R8 Forums banner

1 - 16 of 16 Posts

·
Registered
Joined
·
822 Posts
Shardul, do those mount with the 3M VHB (very high bond) double-sided tape?
 

·
Vendor
Joined
·
4,048 Posts
Discussion Starter #4
Shardul, do those mount with the 3M VHB (very high bond) double-sided tape?
Yes they do.
The car in the picture has seen speeds upto 125 mph and they did not fly off.
 

·
Vendor
Joined
·
4,048 Posts
Discussion Starter #6 (Edited)
You are killing me! Just ordered canards from Eur...

When will yours be available? I’ll try cancelling my order if they have not shipped it already...
I sent you a PM yesterday before I posted this thread with pictures.

I would say about 3 months.
 

·
Registered
Joined
·
19 Posts
I'm not sure I like them; can't decide. I like the idea of carbon fiber canards cosmetically but on these I would prefer that they not extend so far out from the car body so as not to dominate the front-end appearance. Just my .02
 

·
Registered
Joined
·
129 Posts
I chose this design to go by because I felt the front of the vehicle seemed a little anorexic compared to the rear end.

Also wanted it to truly grab some air and have real downforce.

I think the vehicle captured more attention with them and looking back at old pictures, I wish I had them mounted up earlier. Like at Road Atlanta.


Sent from my iPhone using Tapatalk Pro
 

·
Registered
Joined
·
822 Posts
If I'm honest, these do seem to stick out rather far...and conjure up images of Dumbo.
I do like the smaller, but still purposeful, canards of the R8 GT4.
 

·
Registered
Joined
·
19 Posts
If I'm honest, these do seem to stick out rather far...and conjure up images of Dumbo.
I do like the smaller, but still purposeful, canards of the R8 GT4.
Yes exactly, I agree
 
1 - 16 of 16 Posts
Top