i am trying to connect the p3 gauge to the factory oil pressure sensor if our cars have one by the looks of it seems like there is only a sender that tells the engine if there is oil pressure or not
if there is none is there any other locations in the engine that has plugs where i can install...
I spoke to them this morning asking why they had dropped the existing kit for the V8.. the answer is that they are testing a brand new set up. It will be less money than the old one as they have simplified the design, and reduced the amount of cast parts.
This post is with their permission.
Hey Guys, ill be lowering my R8 soon as I recently purchased H&R Springs. Can anyone comment on a ballpark of installation cost. From what I have read this is not a DIY spring install due to programming for the Mag ride.
2009 4.2 6mt.
I can stop my car and then do a very aggressive start from the stop position. The car is warmed up when this occurs. The car will do just fine until I shift to 2nd or third and then the exhaust note changes from the normal higher pitch to a low sounding gurgle. I have some power...